It is best to install The Electrical Bypass at the same time as installing the raceway and junction boxes.

Step 1 Insert one end of the Bypass into connector or conduit 

Step 2  Bend Bypass with hand and insert other end into connector or conduit.                                                                                            

 
 (Shown above 4.0” –square junction box with ¾” trade size bypass)

Step 3  Install one Bypass in every junction box used in the raceway.

Step 4 Starting at one end of raceway insert snake or mouse*. Simply push
snake or blow mouse through with string attached.

Step 5 Use the snake or string to pull wires through as needed.

Step 6 Grab the Bypass by the ears with pliers and tear it out of the junction
box leaving the wire exposed. The Electrical Bypass will give away at
the designed break away slit.

NOTE * A NEW MOUSE WILL NEED TO BE TRIMMED SLIGHTLY.
A USED OR “BROKEN IN “ MOUSE WORKS BEST.

Tools Needed: Fish snake or mouse with string using vacuum or air compressor.

Reasons To Use The Electrical Bypass

1)  It saves you time:  For example A project with two conduit runs with 20 Gang Box Installation the electrician can save 4 hours or more.

2) It increases your profit, saves time, equipment. You could eliminate the need for an additional scissors lift in most cases.

3) It allows you to get more work: For example if you would normally quote 6  hours to snake and pull wire You can now do it in 2 hours, a 66 percent savings.  (Note) actual hours may vary based on the ceiling height, the equipment used and the experience of your people.

Results:  Less time to complete a job + lower labor cost + less equipment cost  = More Profits.

Home - Contact - About us - FAQ - Electrical Contractors supply - Resources - Videos